Adding Buses

You can draw a set of signals as a bus rather than as several separate wires. You do not have to connect a bus physically with the nets that make up the bus.

To add a bus, follow these steps.

1. Select the Add Bus command. See the associated icon shown as follows.
   
   
   
   
2. Point the cursor at the point where the bus starts.
   
   
3. Click and hold the left mouse button to begin the bus.
   
   
4. Click the right mouse button without releasing the left mouse button each time that you want the bus to pivot.
   
   
5. Move the mouse to the desired end point of the bus and click the left mouse button. Unlike the start point, you can place the end point somewhere other than on a net, bus, or pin.