Click the Optimize and Map, Place and Route, Timing Reports, or Interface tab to access the different options within the Implementation Template dialog box. Use the different tabs of this dialog box to set the options described in this section.
Click OK to accept the template, click Cancel to exit the dialog box without changing any settings, click Default to set the default options, or click Help to obtain online help.
Use the Optimize and Map tab, shown in the following figure, to set the optimize and map options.
Figure 5.33 XC4000 Implementation Template Optimize and Map Tab |  |
The XC4000 Optimize and Map tab is identical to the tab described in the “Spartan Optimize and Map Tab” section.
Use the Place and Route tab, shown in the following figure, to set the place and route options.
Figure 5.34 XC4000 Implementation Template Place and Route Tab | |
The XC4000 Place and Route tab is identical to the tab described in the “Spartan Place and Route Tab” section.
Use the Timing Reports tab, shown in the following figure, to set the timing reports options.
Figure 5.35 XC4000 Implementation Template Timing Reports Tab | |
The XC4000 Timing Reports tab is identical to the tab described in the “Spartan Timing Reports Tab” section.
Use the Interface tab, shown in the following figure, to set the translation options.
Figure 5.36 XC4000 Implementation Template Interface Tab | |
The XC4000 Interface tab is identical to the tab described in the “Spartan Interface Tab” section.
