Click the General, VHDL/Verilog, or EDIF tab to access the different options within the Simulation Template dialog box. Use the different tabs of this dialog box to set the options described in this section.
Click OK to accept the template, click Cancel to exit the dialog box without changing any settings, click Default to set the default options, or click Help to obtain online help.
Use the XC4000 General tab, shown in the following figure, to set the general simulation options.
Figure 5.37 XC4000 Simulation Template General Tab |  |
The XC4000 General tab is identical to the tab described in the “Spartan General Tab” section.
Use the XC4000 VHDL/Verilog tab, shown in the following figure, to set the VHDL or Verilog options.
Figure 5.38 XC4000 Simulation Template VHDL/Verilog Tab | |
The XC4000 VHDL/Verilog tab is identical to the tab described in the “Spartan VHDL/Verilog Tab” section.
Use the XC4000 EDIF tab, shown in the following figure, to set the EDIF options.
Figure 5.39 XC4000 Simulation Template EDIF Tab | |
The XC4000 EDIF tab is identical to the tab described in the “Spartan EDIF Tab” section.
